When considering safety in the workplace, responsibility lies with? (QID: 3445)

The load that a new circuit is using can conveniently be worked out by using? (QID: 3470)

Extending an existing ring circuit in a garage attached to a dwelling would be considered as? (QID: 3749)

An approved document would provide guidance on? (QID: 3776)

Horizontal chases in walls should be no thicker than? (QID: 3805)

To which of these areas does the prevention of excessive reverberation not necessarily apply? (QID: 3845)

What is the maximum height at which an entry phone should be installed? (QID: 3870)

Which Act or Regulation applies generally to construction work, whether notifiable or not? (QID: 11128)

Vertical chases in a wall should be no deeper than? (QID: 11237)

When considering installing twin and cpc cable in an area that has a high potential of mechanical damage, the cable should? (QID: 3466)

The number of socket outlets that can be installed on a standard BS1363 ring final circuit is? (QID: 3516)

An electrical installation should be tested, inspected and certified by? (QID: 3552)

It is most important that test instruments are? (QID: 3576)

The connection between the main earthing terminal and exposed conductive parts is known as? (QID: 3654)

Where a new 10kW shower circuit is required, but the consumer unit cannot accommodate, a solution would be to? (QID: 3686)

What is the minimum supply information which the electricity is obliged to provide without specfic request? (QID: 11152)

When undertaking a dead test, which test immediately precedes a polarity test? (QID: 11184)

What is the cable rating for 70 °C thermoplastic insulated and sheathed flat 1.5 mm2 cables with protective conductor using reference method C? (QID: 11202)

When undertaking an IR test on a circuit up to 500 V (excluding SELV and PELV), what is the minimum insulation resistance? (QID: 11218)

What is the minimum intermittent extract ventilation fan rate for sanitary accommodation (not part of a bathroom)? (QID: 11253)